Designed for extending the range of 900 MHz wireless radio devices, the SmartAmp™ is particularly effective when used with Direct Sequence or Frequency Hopping Spread Spectrum radio modems. This unit provides transmit power amplification as well as receive signal gain. The built-in dynamic power sensor in SmartAmp™ adjusts the Radio Frequency (RF) power output level by reading the input signal power. This Automatic Gain Control (AGC) Technology, Teletronics' patented technology effectively making the RF amplifiers "Plug & Play" delivers the maximum output power at various input levels while keeping the distortion at a minimum. Ideal for increasing the range of low power radio devices and to compensate for cable loss in certain installations.
Technical Specifications
Features:
5 Watt
Operating Range:
902-928 MHz
Operating Mode:
Bi-directional, TDD
Transmit Gain*:
27 dB (can be customized to 33dB)
Frequency Response:
± 0.75 dB over operating range
Output Power:
5 Watt (36 dBm) nominal
TX Input Power:
up to 20dBm (100mW)
Receiver Gain:
12 dB typical
Noise Figure:
3.5 dB typical
LED Inidicators:
RED
GREEN/ORANGE
Solid On: Power and Receiving mode Off: No Power
Blinking: Transmitting
Connectors:
N-type, female, 50 Ohm
Lightning Protection:
Quarter Wave Technology
DC Surge Protection:
Available
Power Consumption:
<2A @ 15 VDC (100% duty cycle)
Operating Temperature:
Amplifier: -30 °C to + 70 °C 12V DC injector: -30 °C to + 70 °C
Dimensions:
4.25" L x 3.25" W x 1.75" H
*Transmit Gain is automatically adjusted
SmartAmp 900MHz 5 Watt datasheet
Connection drawing
Sample Site Setup Drawings
Discuss in the Forums (user community input)
Search Wireless Radio External Antenna Pigtails
Ask a Question
Contact an Rfwel Wireless Support specialist with questions on your 900MHz signal improvement project. We design entire systems and stock all required hardware including cables, connectors, antennas, antenna masts, enclosures, grounding straps etc.
Designed for extending the range of 900 MHz wireless radio devices, the SmartAmp™ is particularly effective when used with Direct Sequence or Frequency Hopping Spread Spectrum radio modems. The unit provides the transmit power amplification as well as receive signal gain. Full output power of 1W is achieved with only 4mW input to the amplifier.
CLEARANCE (5)
Wireless System Accessories (47)
Antennas
Remote Site Power
3G/4G Data (38)
Amplifiers & Repeaters (16)
Wireless Monitoring & Control (25)
Broadband Wireless
